Forum Discussion
Asura2006
Altocumulus
AltocumulusPriority group activation and automatically closing connections when higher priorty group goes UP.
Hello we have a configuration where in one pool there are 6 nodes with 2 priority groups of 3 nodes each. 3 nodes with piriority group 1 (backup) 3 nodes with priority group 10 (primary). Priority...
Hi Asura2006 ,
The default behavior of Priority group Activation is when the Backup PG activated it handles your connections , but when higher PG is returned UP and active again , all comming new connections is handled by "main" PGA and the Backup PG handles only Active connections till it completes.
I see this is a good behavior to be done by PGAs and this is the default.
If you see that the new connections don’t be handled by "main" PG when it became actve , check if you enable " manual resume " option under assigned monitor configuration.
> Do you want to transfer active connections to be handled by "main"PG when it became available again ?
specify more please in this section.
Regards
Asura2006Hello,
the problem here is that i want primary PGA to handle ALL the connections after 2-3 minutes from beeing back up. The connections on backup PGA should be closed so that they will be all on primary PGA.
Manual resume on monitor doesn't really help me because it means that each time the primary PGA goes down and up ill have to manually select "enabled" to every node with this monitor.
Asura2006 ,
Do you configure any type of persistence profiles ?
the default behavior , your new connections should be handled by "main "PGA when it becomes available, only Active connections should be handled by the "Back up" PGA till complete.