Forum Discussion
kridsana_52318
Nimbostratus
NimbostratusManuel resume on BIGIP when It's down and restart.
I have LTM in HA-pair BIGIP01 and BIGIP02 .. Active-Active mode
In some scenario where BIGIP02 is restart after service down. Can we make BIGIP02 restart into standby unit and make BIGIP01 take ...
kridsana
Cirrocumulus
Cirrocumulus@What Lies Beneath
I test with 10.2.4 with change setting by using "b db failover.manfailback enable" like in manual
Problem is It will occur standby-standby situation !!!
BIGIP01 , BIGIP02 --> Active , Active ..respectively
{When BIGIP02 down and restart}
BIGIP01 , BIGIP02 --> Active (b unit 1,2) , Standby ..respectively
{When BIGIP01 down and restart}
BIGIP01 , BIGIP02 --> Standby , Standby ..respectively !!!!
This is standby-standby situation -_-
