Forum Discussion
Amresh008
Nimbostratus
NimbostratusLoading config using .scf file
I there any proven method of using the .scf file to load config on a new F5 (there are reasons due to which I am not able to use the .ucs file). I have the scf file from a physical device which I am...
PeteWhite
Employee
EmployeeHi, you have probably make some mistake in your syntax and so it is puking on that. However, you can also use
tmsh load sys config merge file <file path>This loads a proportion of config, so you can load it a small amount at a time and you will probably find the issue that way. You can PM me your config if you want me to take a look
Amresh008Nimbostratus
NimbostratusHi Pete,
Thanks for looking into it, but I have already tried this command. Either the error is an unexpected "}" on any line of the script on the notepad++ file or something else. When I remove the } in that line , it gives another error and so on. I cannot share the config file due to obvious reasons
