Forum Discussion
Ahmad_Mohaidat_
Nimbostratus
NimbostratusCannot restore factory defaults after using 11.5
Dears,
I have upgraded my F5 appliances to the new software 11.5 which was releases three days ago , after that the active/standby appliances didn't see each other and they both appear as disconnecte...
Ahmad_Mohaidat_Nimbostratus
Nimbostratusi worked with F5 Support and the issue resolved after doing a clean install , the bad news is that i lost all my config and i configured the device from the scratch , here are the steps we followed to fix the issue:
- downgrade to 11.4.0
- delete the HD1.3 which has 11.5 installed on in. tmsh delete sys software volume HD1.3
- modify the db key tmsh modify sys db liveinstall.moveconfig value disable tmsh modify sys db liveinstall.saveconfig value disable
- install the 11.5.0 into the HD1.3 tmsh install sys software image <11.5.0 iso file> create-volume volume HD1.3
- reboot to the HD1.5 tmsh reboot volume HD1.3
JGCumulonimbus
Thanks for sharing the solution. Did Support find what the problem was? Was there an issue ID for this?
