Forum Discussion
Steven_J__Willi
Nimbostratus
NimbostratusSync status disconnected
StatusChanges Pending SummaryChanges pending Details Recommended action: Synchronize BNA-OPS-F5-LTM-03.eftdomain.net to group HA_Cluster
Selecting sync device to group and it never works.
Both device status is disconnected.
9 Replies
Brad_ParkerCirrus
Sounds like the devices can't talk to each other on either their HA or Sync connection(i'm guessing they are the same interfaces). Can the devices reach each other on those interfaces?
Steven_J__WilliOk how can I verify connectivity through CLI? It seems I cannot access the vCMP guest through ssh?
- Brad_ParkerHow are you able to see that they are in a disconnected state? You can't ssh to the same IP as you are connecting via the GUI? Are you connecting to a self IP for that or the management?
- Steven_J__Willi
The disconnect status shows when I try to config sync. Says to sync devices to group and when I try nothing happens. I cannot access ssh via same IP i get to vCMP guest via browser. Its strange.
- Brad_ParkerCheck your port lock down settings on the self IP. The selfIP you are using for sync needs to have udp 1026 allowed at a minimum.
- Steven_J__Willi
Can I not use HA vlan for config sync?
- Brad_ParkerYou certainly can, just need to have port lock down configured properly. https://support.f5.com/kb/en-us/solutions/public/13000/200/sol13250.html
- Steven_J__Williuh wonder what the issue is here. I am going to remove all settings and start again. Its been like 8 months since I did this. I think I will document this time.
- Steven_J__WilliOk that worked. Not sure what the issue was, but everything is in sync now. Very strange. Can the "HA capacity" dictate which one is active?
