Forum Discussion
romolo82
Cirrus
CirrusIssue on management route
Hi everybody,
I added a static route on the management interface to send logs towards Syslog server; if I type the ip route get "IP address" command, I can notice that destination address should be reached by the right interface (management).
But if I perform a tcpdump on the mgmt interface, with a filter on the destination IP address, I can notice that the source IP address becomes another, NOT the management IP.
Can youhelp me to solve this issue?
Thanks a lot in advance, best regards.
Maybe you are hitting the bug below:
K26457459: Syslog messages are sent with incorrect source IPDataplane is often prefered than managment when sourcing the traffic:
K13284: Overview of management interface routing (11.x - 17.x)
https://support.f5.com/csp/article/K13284
- Nikoolayy1
MVP
Maybe you are hitting the bug below:
K26457459: Syslog messages are sent with incorrect source IP Just to clarify, Did you set this route via cli or UI?
if its management it has to be the cli, the ui is only the data plane for prod traffic.
K13284 commands are key here and make sure your gateway is correct!
romolo82Thanks a lot, I solved with this solution: https://support.f5.com/csp/article/K26457459
- romolo82
I add that in the routing tble there is a default route that use the interface with the wrong IP address that now is forwarding logs; but a static route shouldnt' be preferred than a default route?
- Lidev
Hi romolo82,
I have encountered this problem before 🙂
Have you set the local IP parameter on Syslog Configuration remote logging ?
K26457459: Syslog messages are sent with incorrect source IP
regards- Nikoolayy1
Yup, so did I and this why I also thought about K26457459 🙂
- Nikoolayy1
Dataplane is often prefered than managment when sourcing the traffic:
K13284: Overview of management interface routing (11.x - 17.x)
https://support.f5.com/csp/article/K13284
- romolo82
Thanks a lot!
