Forum Discussion
Sarah_258804
Cirrus
CirrusDo I need a "Route" configured for route domain 0?
Hi all, I'm currrently using route domain 0 for everything on the Big-IP. I've not created any other route domains. When I go to Network > Routes, there are no routes listed. Do I need to create a default route for route domain 0? What does route domain 0 use as its default route if I don't specify one?
Micros_88999Nimbostratus
For management access, I believe there is a default route set, but that is for management traffic. (tmsh list sys management-route)
outgoing: If there is an interface connected, where the network matches the destination, the device will use that interface. (tmsh show net route)
incoming/replies For replies, the device will use: Auto Last Hop. The device will send the reply to the MAC address on the interface where it received the request.
I hope I could help!
Yann_Desmarest_Nacreous
Hello,
If you can reach the F5 or the F5 can reach all required resources without any default gateway, it's fine, no need to add a route. Otherwise, you will need to add a default route on Network >> Route or using a tmsh command :
create /net route 0.0.0.0/0 gw 30.99.99.254No need to take care of the route domain. If you don't specify any route domain in the route configuration it's a route used within route domain 0.
- Yann_Desmarest_You can use the following : tcpdump -s 0 -vvv -i eth0 host your_destination_ip
- Yann_Desmarest_Simple, if the destination you try to reach is directly connected to the F5 by a Self IP, it's fine. If you are able to reach a destination that is not directly connected, the traffic probably use the management port. To make sure, you can launch a tcpdump command on the cli and see if there is traffic outgoing to the mgmt
- Micros_88999If its the reply (for a client hitting a virtual server f/e), then f5 using the Auto Last Hop feature. Nor replies it wont use the management interface.
Yann_DesmarestHello,
If you can reach the F5 or the F5 can reach all required resources without any default gateway, it's fine, no need to add a route. Otherwise, you will need to add a default route on Network >> Route or using a tmsh command :
create /net route 0.0.0.0/0 gw 30.99.99.254No need to take care of the route domain. If you don't specify any route domain in the route configuration it's a route used within route domain 0.
- Yann_DesmarestYou can use the following : tcpdump -s 0 -vvv -i eth0 host your_destination_ip
- Yann_DesmarestSimple, if the destination you try to reach is directly connected to the F5 by a Self IP, it's fine. If you are able to reach a destination that is not directly connected, the traffic probably use the management port. To make sure, you can launch a tcpdump command on the cli and see if there is traffic outgoing to the mgmt
- Micros_88999If its the reply (for a client hitting a virtual server f/e), then f5 using the Auto Last Hop feature. Nor replies it wont use the management interface.