Forum Discussion
angerica I have not migrated from one to the other but you might try the following.
- angericaNimbostratus
Hi SIr
Thank you for the kb, i was wondering as there is existing configuration for viprion, if i load the ucs file from boh-ip 5050 to virpiron what willh happen to the existing config of virpion?
angerica If you are loading two devices into one VPR you could try creating an SCF of each device and then using the "load sys config from-terminal merge" as Mohamed_Salah_ has mentioned below. The following article is how you would go about creating the SCF file. This will take some manual editing of the configuration that you load for referenced interfaces but it would speed things up a bit.
Hello,
Since you don't need all config, and just pool and virtual servers and some LTM objects, you can open the bigip.conf file (from the source device that you need to copy config from), and start copying the configuration as text, and then migrate these objects using the below command:
Access new device
#load sys config from-terminal merge verify
and verify for any erros and try to fix them, Then run the same command without verify.
#load sys config from-terminal merge
https://my.f5.com/manage/s/article/K81271448
Thanks,
Salah