Can't acess F5 VE on https

Maybe your virtual network interfaces got remapped?

 

 

You can log in on the console and doe a tcpdump on eth0 to see what kind of IP addresses are arped for on the MGMT interface. Maybe that gives a clue.

 

hi harshpal

 

 

have you licenced the unit yet?

 

 

on the latest version of VE, i found that the 'activate' licence button didn't work. it basically just sat there doing nothing. then for some unknown reason the gui became very unreliable. it would work one minute, but not the next. to fix this, i licenced the unit via command line and everything sprung to life

 

 

just an idea

Hello Skuba ,

 

 

 

Thanks for your words , i can't login to via ssh and GUi so i could not licencee the unit ,Yesterday some how after re installing it was working but today again when i restart the VM ,i am facing the same issue .Any thing else i can try ?

 

 

Harsh

Hello Skuba ,

 

 

 

Thanks for your words , i can't login to via ssh and GUi so i could not licencee the unit ,Yesterday some how after re installing it was working but today again when i restart the VM ,i am facing the same issue .Any thing else i can try ?

 

 

Harsh

i dot think so this can be issue with arp as ping is working and even i can telnet on 443 .

 

 

Harsh

 

issue is still on ,Can any one shoot this ???

 

 

 

Harsh

Hi Harsh

 

 

I don't understand how you've installed the software without having access to the command line and/or GUI? In my opinion, you need to get to a command line and issue the get_dossier command to licence the system. This would be my recommendation before troubleshooting anything further

 

 

John

Hello Skuba,

 

 

Thanks for your help ,i have restated the Vm and i got the https acees but this is intermittent ,Some time it works some time don't .Even after licensing the unit when i restarted the VM i lost the https .

 

 

For now i am good thnaks a lot .

 

 

Regards

 

Harshpal

 

Intermittent access problems like this sound like a duplicate IP address may be present.

 

"i have installed LTM VE but i am not able to access it via https and SSH ,Earlier it was working fine dont know all of sudden what happened .i can ping the MGMT IP ,even i can telnet on 443."

 

 

Had this same issue on our LTM. It seems like the admin service was having issues. I logged in via console and ran:

 

 

 

bigstart restart tmm

 

 

 

That fixed the issue, but caused a failover.

 

 

 

Not sure how much all that applies to you (the commands may be different in your version) but see if you can restart that service somehow.