Forum Discussion
NimbostratusAbout Factory reset
We have a LTM-6900,after we type a commond:tmsh load sys default-config ,we import the new .ucs files ，the ltm always appears the error tips ：BIGpipe self IP address creation error: 01070277:3: The requested vlan, vlangroup or tunnel (vlan_internal) was not found.
Anyone can help me，thanks！
2 Replies
amolariCirrostratus
seems you are running v10.x Do you have configured the hostname again prior to load the ucs?
From: https://support.f5.com/kb/en-us/solutions/public/11000/300/sol11318.html
--
Verify hostname
The UCS restore operation restores the full configuration only if the hostname of the target system matches the hostname on which the UCS archive was created. If the hostname does not match, only the shared configuration is restored.
You can set the hostname of the BIG-IP system on the System > Platform screen of the Configuration utility, or by using the bigpipe system hostname command at the BIG-IP command line.
Base configuration
When restoring only the shared portion of a UCS archive, the base configuration of the target system must include all Virtual Local Area Networks (VLANs) and other objects referenced by name in the shared configuration. If you are restoring the archive on a newly-installed system, use the Configuration utility's Setup Wizard to configure the base configuration to match the configuration you are restoring.
airman525_19311Thanks for your advice a lot. At last，we import the scf profile to cover all the configuration of target system (contains the hostname and the vlan messages and another base configurations). The command of gathering the file is:tmsh save sys xx.scf
