Technical Forum
Ask questions. Discover Answers.
cancel
Showing results for 
Search instead for 
Did you mean: 

Where is F5 BIG-IP LTM node Field Description

sungwon
Nimbostratus
Nimbostratus

Hi All, I have one question for yours about iControl REST API ltm.

 

Device traffic information was obtained through "tmsh show ltm node" cli.

 

so what is mean bits, packet, ? it just total counter ?

 

Status

 Availability  : unknown

 State     : enabled

 Reason     : Node address does not have service checking enabled

 Monitor    : none

 Monitor Status : unchecked

 Session Status : enabled

 

Traffic        ServerSide General

 Bits In            0    -

 Bits Out           0    -

 Packets In          0    -

 Packets Out          0    -

 Current Connections      0    -

 Maximum Connections      0    -

 Total Connections       0    -

 Total Requests        -    0

 Current Sessions       -    0

 

 

1 ACCEPTED SOLUTION

crodriguez
Legacy Employee
Legacy Employee

Bits In and Bits Out are counters that represent the total number of bits sent between the BIG-IP system and the back end node since the BIG-IP system started up or since the last time statistics for the node were reset. Packets In and Packets Out operate similarly except they represent the number of packets sent between the System and the specified node. All statistics counters can be reset at any time by issuing the command:

tmsh reset-stats /ltm <node>

Does that answer your question or are you looking for additional information on all the counters?

View solution in original post

2 REPLIES 2

crodriguez
Legacy Employee
Legacy Employee

Bits In and Bits Out are counters that represent the total number of bits sent between the BIG-IP system and the back end node since the BIG-IP system started up or since the last time statistics for the node were reset. Packets In and Packets Out operate similarly except they represent the number of packets sent between the System and the specified node. All statistics counters can be reset at any time by issuing the command:

tmsh reset-stats /ltm <node>

Does that answer your question or are you looking for additional information on all the counters?

First of all, thank you for your reply.

 

but i want more information about counter, where is document site ?