Forum Discussion
One Connect Profile will completely detach the client-side TCP connection from your server-side connections, so that your dont have to care about already established connections. Each incomming client-side HTTP request will be load balanced (based on Pool-Priority-Groups availibilites) and then use a pooled service-side connection to the individial members.
OneConnect enables you to switch between Pool-Priority-Groups without closing the client-side connection, the very next HTTP request will be load-balanced to the Master/Fallack Priority-Group as needed.
If applying a OneConnect Profile to your Virtual Server is not a problem, then you can continue to use your single Pool setup including Priority-Based Activation. The only change needed would be to adjust your Health-Monitors, so that a node will delay a state change to UP for 2 minutes (via "Time Until Up" setting).
Let me know if you need further assitance to get the OneConnect setup running.
Cheers, Kai
Hey Asura2006 - if Kai's response solved your issue, could you please hit the Accept as Solution button, so future users dealing with the same problem can easily find the solution to their issue?
- Asura2006Nov 29, 2022Altocumulus
Hello,
to be honest i have to test all the potential solutions presented here in ths thread and ill get back as soon as i test it
Especially the one that xuwen wrote below because it needs a little bit of configuration on my side.