Forum Discussion
NimbostratusCannot access machines after TLS 1.0 and 1.0 was disabled in server side(both vip and pool members on port 443 without any client or server ssl profile)
MVPHi Binoy,
can you describe why you are not able to access the service? Is the Virtual Server marked as down because the pool members are marked as down? If so - what kind of health checks do you have enabled for the pool members? Do they maybe rely on TLS1.0 or TLS1.1?
Or do you get a connection reset from the pool members?
Did you try to do a packet capture on the F5? You can configure the BIG-IP to log the reset cause:
K13223: Configuring the BIG-IP system to log TCP RST packets
So it's mandatory to understand from where the problem comes in order to resolve the issue.
KR
Daniel
NimbostratusHi Daniel,
Thank you for your reply and sorry for the delay in response , not able to access service means the service is not down in ltm , however when the application team disable TLS1 and 1.0 on their servers, the ldap(ADFS ) stops working , they suspected something on the F5 for which I specified that F5 is only a pass though ,I strongly felt this is something related to application however I wanted to confirm it .
I referred the below and it says SSL Pass through traffic where BIP IP just pass the the traffic from client to servers , So I only wanted to make sure that we are right that F5 does not do any reset when they disable tls v1 v0 on their servers , second it since this is production we have not got chance for any downtime to test it again.
https://support.f5.com/csp/article/K65271370 #
the health monitor is tcp
here is the same sample
ltm virtual VIP12_443 {
destination VIPex/172.16.1.1:https
ip-protocol tcp
mask 255.255.255.255
pool pp
profiles { ----------------------- No Client or sever SSL profile attached / Health Monitor is tcp
tcp { }
}
source 0.0.0.0/0
source-address-translation {
type automap
}
translate-address enabled
translate-port enabled
vlans {
/bb
}
vlans-enabled
vs-index 25
}
