Forum Discussion
When upgrading to 11, I get "The configuration has not yet loaded" error
Hello all,
I have a fairly new LTM only implementation that was running 10.2.2. I wanted to upgrade to 11 before putting it into production. The only thing on here right now is Exchagne 2010 objects from running the Excahnge 2010 template. When I tried to upgrade to 11, it seems to install fine, but when I boot into it, it has a yellow band across the top saying that "The configuration has not yet loaded. If this message persists, it may indicate a configuration problem" and all objects are gone. I followed all documentation exactly about 4 times on both nodes. Same result. I also upgraded it to 10.2.4 to see if that made a difference, but nothing. Searching I found a known issue about a Citrix irule with double quotes causing it, but I am not using that particualr one. any help would be appreciated.
Thanks.
- Mike_Maher
Nimbostratus
Steve, - SteveMP
Nimbostratus
Thanks for the response, - hoolio
Cirrostratus
What's the full object that starts on line 103? - SteveMP
Nimbostratus
Posted By hoolio on 05/07/2012 02:17 PMhttp://support.f5.com/kb/en-us/solu...13183.html
- SteveMP
Nimbostratus
I wanted to post the workaround in case anybody has the same issue and stumbles upon this thread. Basically i had to ssh to it and manually delete the whole line "parent id 0" from each route domain. Then run "/usr/libexec/bigpipe daol" which finishes the conversion. Then you can go into each route domain and set the parent id back to 0. Hope that helps someone! - Evan_26899
Nimbostratus
We found a number of issues that can cause the config not to migrate successfully from v10 (I'm also on 10.2.2) to v11. Hopefully this may again help someone else!- F5-User_132771
Nimbostratus
Hey - thank you. I was having the same problem upgrading from version 10.2 to 11.4 - I ran the command above /usr/libexec/bigpipe daol and this resolved my particular case. Thanks again
- Evan
Nimbostratus
We found a number of issues that can cause the config not to migrate successfully from v10 (I'm also on 10.2.2) to v11. Hopefully this may again help someone else!- F5-User_132771
Nimbostratus
Hey - thank you. I was having the same problem upgrading from version 10.2 to 11.4 - I ran the command above /usr/libexec/bigpipe daol and this resolved my particular case. Thanks again
Recent Discussions
Related Content
* Getting Started on DevCentral
* Community Guidelines
* Community Terms of Use / EULA
* Community Ranking Explained
* Community Resources
* Contact the DevCentral Team
* Update MFA on account.f5.com