Standby Unit will not remain Standby

I do not have the serial cable.

 

I have the peer management address entered on both systems.

 

 

I also have the Unicast section filled out with the peer name, local address, remote address, and port 1026.

 

 

I can perform a config sync to the backup unit but then my floating IP addresses get the unit ID of the other unit.

 

The floating IP's should maintain the unit ID for each one they are configured on ....correct.

 

 

Unit 1 Floating IP's became Unit 2 Floating IP's when I synched from unit 2 to unit 1.

 

 

I am sure I am missing something here.

 

 

Thanks

 

Mike