Monitor showing Down

Or the other way..to make the pool member show UP is to create the monitor object "/HeartBeat/Hearbeat.htm" on the server, right?yes

nitass,

 

 

We found that monitor traffic is not hitting the server at all from the IIS logs. Server owner says,

 

 

https://10.20.30.10/HeartBeat/Heartbeat.htm --> will not work

 

 

bcoz

 

 

we put a hosts header on 443. It' responds to https://rxpsws/

 

 

but when i tried, curl -kv https://rxpsws/heartbeat/heartbeat.html - got the below message

 

 

* Couldn't resolve host 'rxpsws'

 

 

Is thr something we can do from the F5 or on pool member side to concretely check why or why not traffic is reach the server?

 

 

 

 

can you try this send string?

 

 

GET /HeartBeat/Heartbeat.htm HTTP/1.1\r\nHost: rxpsws\r\nConnection: Close\r\n\r\n

 

 

sol2167: Constructing HTTP requests for use with the HTTP or HTTPS application health monitor

 

http://support.f5.com/kb/en-us/solutions/public/2000/100/sol2167.html

nitass,

 

 

i will try the new string.

 

 

Do you see any reason why there are no hits in the IIS logs, even though we sending traffic? Is thr a way we can verify this.?

Do you see any reason why there are no hits in the IIS logs, even though we sending traffic? Is thr a way we can verify this.?i do not think traffic does not hit the web server since we do see 404 not found response. i think your application team means traffic does not hit the web server virtual host (rxpsws).

is there a way we can simulate monitor traffic on port 445 as well.

 

 

The same pool server are down for port 443, have another NIC, dual-homed, carrying another IP as a pool member in a different pool. This member is also showing down for port 445.

is there a way we can simulate monitor traffic on port 445 as well. what is the protocol e.g. http, https, cifs, etc?

netbios or SMB, i think.

e.g.

[root@ve1023:Active] config  smbget -u administrator -p password smb://200.200.200.103/test/hello.txt 
Using workgroup MYGROUP, user administrator
smb://200.200.200.103/test/hello.txt

[root@ve1023:Active] config  cat hello.txt
hello world

do i just execute the cmd as it is ..changing the relevant values? and what about administrator and password?