LTM config issue

Hi The LTM is connected to the same LAN segment 10.4.0.0/24, the same way I setup for 10.2.0.0/24 ( this one is working for ping, ltm config, access, etc, happy). I ignored the ping issue on the LTM for now, but when I tried to add a new node using 10.4.0.0/24, LTM monitoring failed, right away I know something was not right. If you look at configs that I posted earlier, I added 10.4.0.0/24 on the internal interface, but that did not do any good. Any thoughts?

back up a little. What vlan is "internal"? Is it tagged? What vlan is 10.4.0.0/24 supposed to be on? Have you assigned the self-IPs to the correct vlan? It's difficult to guess what's going on, except to suspect that you may have added the IP to the wrong vlan (if they are directly connected to the same lan segment), or if they are not directly connected, then you don't have a route configured or the router is not configured to forward the packets it's getting.

Hi, this is what I have is working right now meaning I can create VIP and it's accessible. All interfaces are configured untagged. 1. Internal Vlan (10.2.0.0/24) -> selfIP .145/floating .155 2. External Vlan (192.168.50.0/24) --> selfip .145/floating .155 3. HA Vlan (10.3.0.0/24)--> selfip--> 10.3.0.145/floating .155 4. Management (10.1.0.0/24) -->selfip-->10.1.0.145 5. Gateway--> 192.168.50.1 Now I am having a new network 10.4.0.0/24, GW 10.4.0.1, assigned .11/.12 to two web servers. The steps I configured in LTM and it's not working. How would you add config a new network in LTM? add a new config: 1. Vlan->new selfip--> 10. 4.0.145, float-->10.4.0.155 on internal VLan

just want to make a note from my last post is that 10.4.0.1 is a gateway that being configured only for the web servers NOT on the LTM.