Forum Discussion
RAQS
Cirrus
CirrusLoad sys config command in CLI
Hi all, Hope you are doing great. What will be the impact, if I run command "tmsh load sys config" instead tmsh load sys config verify. Regards, RAQS
tmsh load sys config will verify and load the config. It will change the running config.
tmsh load sys config verify will only verify the config. It will not change the running config.
Daniel_Wolf
MVP
MVPHi RAQS,
verify is like a dry run. It will not do anything expect of verifying syntax.
However a tmsh load sys config will also verify the config you are importing.
Depending on what you plan to do, pay attention to use the merge parameter. Otherwise you might overwrite stuff that you will desperately miss afterwards.
KR
Daniel
RAQSCirrus
CirrusThanks Daniel for your time and reply. So "tmsh load sys config" will also not make any impact while running it in production boxes ? It will not change running config ?
Regards,
Raqs
- Daniel_Wolf
tmsh load sys config will verify and load the config. It will change the running config.
tmsh load sys config verify will only verify the config. It will not change the running config.
- RAQS
Thanks Daniel. So will it have an impact ? Suppose if I run this on production box then what impact I can expect ?
SnozzleadelectricgtrNimbostratus
Raqs what was your outcome from this in PROD. In a Active-Standby. My experience it won't down the box. HOwever, you'll have changes pending messages. After hours, from a copy of the running-config you just paste that into the running config and sync changes. Crisis averted! Maybe you have to stop processes?