Forum Discussion
NimbostratusINOPERATIVE state
HI All, I want to configure acrive-active system. With 1st VE everething is ok but 2nd is in INOPERATIVE satate. Please advise how to change this state to ACTIVE? Thank you in advance!
35 Replies
vk0212_176740i have to use gui for administration purposes but i can't open GUI. VE in INOPERATIVE state. So i can use only console.
- vk0212_176740do know where i can find manual with the same information bit for - console?
nitass_89166Noctilucent
i have to use gui for administration purposes but i can't open GUI. VE in INOPERATIVE state.
doesn't it work when accessing management interface ip?
do know where i can find manual with the same information bit for - console?
what information are you looking for?
- vk0212_176740when I accessing management interface ip - is doesn't work. I am looking for: how to reactivate license due to console.
- nitass_89166can you post the get_dossier screenshot?
- nitass
Employee
i have to use gui for administration purposes but i can't open GUI. VE in INOPERATIVE state.
doesn't it work when accessing management interface ip?
do know where i can find manual with the same information bit for - console?
what information are you looking for?
- vk0212_176740when I accessing management interface ip - is doesn't work. I am looking for: how to reactivate license due to console.
- nitasscan you post the get_dossier screenshot?
