Forum Discussion
AlvinNG_GTI
Altostratus
AltostratusHow to configure the AOM for rSeries hardware appliance
Hello,
As I encountered something when I want to shutdown the rSeries hardware appliance with F5OS 1.3.1 by CLI "halt". The process as smooth and shown "The system was halted". But I tried to Power on the appliance via front panel touch screen NO any respond.
Therefore, I would like to configure the AOM for remote control the rSeries Power On/Off the appliance.
But I just can apply the AOM networking settings, no any command for configure the AOM user such as CLI "aom_setup_user".
May you experienced this behavior or there have solution?
If so, don't mind share to us. Thank you very much.
Thanks and Best Regards,
Alvin Ng
TMDNimbostratus
If the power was turned off with the "halt -p" command, you should be able to power on using the touch panel.
Please note K22954168.
https://support.f5.com/csp/article/K22954168
AlvinNG_GTIHi TMD,
Thanks for your sharing.
Let me try it in my rSeries appliance. If it is fine, I will use this method rather than configure AOM.
SInce my concern as no any respond to power on the appliance from touch screen before, and require to unplug and re-plug the power pord action. That make me create the post to discuss how configure the AOM on rSeries.
Thanks and Best Regards,
Alvin Ng
- Nikoolayy1
MVP
With the F5OS the AOM is also called now LOP (Lights Out Processor) , so search for info about it.
jdsheweyPretty sure you have that backward - LOP is now called AOM - starting circa version 11 and the iSeries units (after the buffalo jumps). Mine (an rSeries unit) has "AOM" on the front LCD panel for the info/config.
