Forum Discussion

Techgeeeg_28888's avatar
Techgeeeg_28888
Icon for Nimbostratus rankNimbostratus
Jun 09, 2015

Fail-over port on Viprion blades

Hi Everyone,

 

I have two VIPRION chassis with 3 blades per chassis, I have observed a Failover RJ-45 port on each blade. I would like to know how can i utilize these ports for fail-over configuration??

 

Regards,

 

application delivery
availability
deployment
LTM

4 Replies

  • nitass's avatar
    nitass
    Icon for Employee rankEmployee
    Jun 10, 2015

    I would like to know how can i utilize these ports for fail-over configuration??

     

    no, i do not think so.

     

  • Techgeeeg's avatar
    Techgeeeg
    Icon for Nimbostratus rankNimbostratus
    Jun 15, 2015

    Hi Nitass,

     

    Thanks for the reply but what is the propose of the Fail-over Ports than??

     

  • arpydays's avatar
    arpydays
    Icon for Nimbostratus rankNimbostratus
    Jun 15, 2015

    Hi,

     

    see below, the port is not used on the Viprions

     

    SOL12326: Serial failover is not supported between VIPRION chassis

     

    SOL13915: Configuring network failover for redundant VIPRION systems (11.x)

     

    cheers