Forum Discussion
Sonny
Cirrus
CirrusConfiguring VS to access LTM
I have 2 management interfaces, x.x.10.1 and x.x.20.1. I normally access the device through 20.1. So I created a vs to access 10.1. However, looking at the tcpdump, I don't see any response back from...
Kevin_Stewart
Employee
Employeemost likely bc the self-IP is on the same network as the VS
That shouldn't matter. I just tested again with an internal VLAN self-IP that I can't access locally, and that worked. SNAT must definitely be disabled when using a self-IP. Very strange.