Forum Discussion

Ana_Saiz_4489's avatar
Ana_Saiz_4489
Icon for Nimbostratus rankNimbostratus
Jun 02, 2014

11.4.0 Peer device "disconnected" but syncing

Hello all   Last week I upgraded a pair of BIG-IP 6900 from 10.2.2 to 11.4.0, following the recommended procedure for active-standby configurations.   Once both nodes were upgraded, I noticed t...
application delivery
availability
fail over
LTM
management
TMOS
Ana_Saiz_4489's avatar
Ana_Saiz_4489
Icon for Nimbostratus rankNimbostratus
Jun 02, 2014

Thanks Patrick

 

The point is I don't have it upgraded anymore, as the customer requested to perform a rollback, so I need to figure this out before the next upgrade attempt.

 

So, to keep it in mind for the next upgrade, I'd need to make sure the nodes see each other through the management interface, and have the failover cable disconnected?

 

Thanks again, Ana