Forum Discussion
Ana_Saiz_4489
Nimbostratus
Nimbostratus11.4.0 Peer device "disconnected" but syncing
Hello all
Last week I upgraded a pair of BIG-IP 6900 from 10.2.2 to 11.4.0, following the recommended procedure for active-standby configurations.
Once both nodes were upgraded, I noticed t...
Hi Ana
Run this command:
tmsh show sys failover cableIf it shows as unset you don't have a cable, if it shows cable status you have one. As for the bug, sorry but I can't find the SOL article.
Had this bug myself after an upgrade a few months ago which is why I knew about it.
/Patrik