Upgrade Verification - CLI tips and tricks

[Kevin_Davies]

I mentioned recently in a conversation that I use to use the CLI to generate a snapshot of the bigip run state for pre/post comparison after an upgrade. By accident, I ran across these scripts today so here they are for your enjoyment. They are circa big-ip v12 so update as needed, feel free to post updated versions in the reply and i will tick them as the answer even.

Pre-Change (Now supports partitions)

# tmsh -c "cd /; show ltm virtual recursive" | awk '/Ltm::Virtual/ { printf $NF } /(Availability|State)/ { printf ":"$NF } /Reason/ { print ":"$NF} ' > bigip-virtual-state.pre 
# tmsh -c "cd /; show ltm pool recursive" | awk '/Ltm::Pool/ { printf $NF } /(Availability|State)/ { printf ":"$NF } /Reason/ { print ":"$NF} ' > bigip-pool-state.pre 

Post Change

# tmsh -c "cd /; show ltm virtual recursive" | awk '/Ltm::Virtual/ { printf $NF } /(Availability|State)/ { printf ":"$NF } /Reason/ { print ":"$NF} ' > bigip-virtual-state.post
# tmsh -c "cd /; show ltm pool recursive" | awk '/Ltm::Pool/ { printf $NF } /(Availability|State)/ { printf ":"$NF } /Reason/ { print ":"$NF} ' > bigip-pool-state.post 

Comparison

# diff bigip-virtual-state.pre bigip-virtual-state.post 
# diff bigip-pool-state.pre bigip-pool-state.post 

 

[G-Rob]

That is very useful! Thanks for sharing, Kevin.