Nodes status show blue status

[davidy2001]

Hi Please see the below. The left red circle labeled is nodes list. the right one is from Local Traffic-----> Network Map. 

For the same virtual server, why the left one is not enabled status? Thanks

[Mohamed_Ahmed_Kansoh · Accepted solution]

Hi @davidy2001 , 
     The nodes are shown with blue squares because you do not assign a health monitor for them. 
so to show there status and make them available , you need to assign a health monitor. 
> Steps 
- open one of your nodes. 
- Configure it as below snap shot : 

and Click update. 
- open the Nodes list again you will see it becomes available like below snap shot : 

> I recommend that , Do not assign much health monitors on your device , the pool members health monitors is sufficient , make your virtual server or application available. 
- much monitors make a headache to you device , and cost CPU processing as well , you need to reduce  your monitors. 

Hope this helps you. 
Regards 

[davidy2001]

Great! Thank you

[Mohamed_Ahmed_Kansoh]

Hi @BarbaraNelson , 
If the selected solution in this thread hasn’t fit with your issue , Please clarify your request and design , to be able to help 
Regards