Forum Discussion
davidy2001
Cirrus
CirrusNodes status show blue status
Hi Please see the below. The left red circle labeled is nodes list. the right one is from Local Traffic-----> Network Map. For the same virtual server, why the left one is not enabled status? Thank...
Hi davidy2001 ,
The nodes are shown with blue squares because you do not assign a health monitor for them.
so to show there status and make them available , you need to assign a health monitor.
> Steps
- open one of your nodes.
- Configure it as below snap shot :and Click update.
- open the Nodes list again you will see it becomes available like below snap shot :> I recommend that , Do not assign much health monitors on your device , the pool members health monitors is sufficient , make your virtual server or application available.
- much monitors make a headache to you device , and cost CPU processing as well , you need to reduce your monitors.
Hope this helps you.
Regards
Hi davidy2001 ,
The nodes are shown with blue squares because you do not assign a health monitor for them.
so to show there status and make them available , you need to assign a health monitor.
> Steps
- open one of your nodes.
- Configure it as below snap shot :
and Click update.
- open the Nodes list again you will see it becomes available like below snap shot :
> I recommend that , Do not assign much health monitors on your device , the pool members health monitors is sufficient , make your virtual server or application available.
- much monitors make a headache to you device , and cost CPU processing as well , you need to reduce your monitors.
Hope this helps you.
Regards