LTM to Junos LACP Query

[Jason_Chapman_3]

Looking for a little assistance please, I work with LACP between LTM's and Cisco often, normally this is quite straight forward and I don't experience issues here. I am trying to bring up a LACP bundle between a Juniper stack and a set of LTM's with the below config, two 10gb interfaces in an interface range linked to a vanilla LAG interface.

LTM config is below:

Ideally I'd like both sides Active but have tried various combinations of Active/Passive, periodic slow and fast. No scenario will bring this LAG up, I can't spot what I am doing wrong here, does any one have a working example of LACP to Junos from TMOS they could share?

Link details from TMOS are below advise/help appreciated.

[thistuffjuice_3]

Hello

Can you provide LACP debug (traceoptions) or log output from your JUNOS switch? Have you also checked your /var/ltm log directory?

https://www.juniper.net/documentation/en_US/junos/topics/reference/configuration-statement/traceopti...

If you enter show lacp interfaces on JUNOS, can you see your interfaces involved in LACP?

show interfaces ae20 statistics should also give you some helpful output.

[VFB]

Was there ever a resolution to this issue? I ran into the same problem earlier tonight.

[Simon_Blakely]

VFB,

What version of BigIP are you running, and on what hardware?

[VFB]

12.1.2 in DMZ and 13 in Core. Both instances have issues with LACP. I noticed when I disabled LACP, the trunk comes up, but still no traffic.