cancel
Showing results for 
Search instead for 
Did you mean: 

HTTP monitor that goes to a single location instead of each pool member

Shurton
Nimbostratus
Nimbostratus

I'm want to create a reverse HTTP monitor that all goes to a single source instead of going to each pool member. Can this be done within the HTTP monitor template, or is there another way to do this, maybe through an iRule?

Any suggestions would be appreciated.

1 ACCEPTED SOLUTION

Create a new monitor of type HTTP, and set the "Alias Address" parameter to the unique address you want to monitor and also the "Alias Service Port" if you want to also force a specific port. Associate that monitor to your pool

View solution in original post

2 REPLIES 2

Create a new monitor of type HTTP, and set the "Alias Address" parameter to the unique address you want to monitor and also the "Alias Service Port" if you want to also force a specific port. Associate that monitor to your pool

  • I originally tried that with no luck, but after looking at it again, it works now. thx