when syncronizing an ltm appliance to the peer ltm says on gui below, but there is no line 55 in the defined file

Operation Status
Configsync Mode: Push
Transferring UCS to peer...
Installing UCS on peer...
Obtaining results of remote configuration installation...
error: bad line 55 in state file /var/lib/logrotate.status
error: could not read state file, will not attempt to write into it
Saving active configuration...
Current configuration backed up to /var/local/ucs/cs_backup.ucs.
Product : BIG-IP
Version : 10.2.1
Hostname: UCS   : f5lb1.somedomain.com
          System: f5lb2.somedomain.com
Installing --shared-- configuration on host f5lb2.somedomain.com
Installing configuration...
Post-processing...
Reading configuration from /config/low_profile_base.conf.
Reading configuration from /defaults/config_base.conf.
Reading configuration from /config/bigip_sys.conf.
Reading configuration from /config/bigip_base.conf.
Reading configuration from /usr/share/monitors/base_monitors.conf.
Reading configuration from /config/profile_base.conf.
Reading configuration from /config/daemon.conf.
Reading configuration from /config/bigip.conf.
Reading configuration from /config/bigip_local.conf.
Loading the configuration ...

Checking configuration on local system and peer system...
Peer's IP address: 10.0.0.2
Synchronizing Master Keys...
Saving active configuration...