Forum Discussion
Nimbostratuswarning on LTM log after vCMP is enabled
Hello, on version 11.5 (with and without HF) when vCMP is enabled on LTM log there is this warning "Over allocation of disk has been detected. Please check for unused application volumes.", after every reboot. This happens only with 11.5.0 (with and without HFx), on 11.4.1 the warning not appears in the logs. this is only a warning, despite it the system works fine, but I'd like to explain the meaning of the warning and if it is only a "cosmetic bug".
Do you have any experience on this?
TIA
7 Replies
Damiano_Colla_9I notified the same issue and as an addition I can say that the log is present only in the host appliance and not present in any guest configured.
d.-
- Damiano_Colla_9
As an update, I've just noticed the same issue with ver. 11.5.1 with and without HF2.
d.-
mbbusby_59444I see the same thing on 11.5.0 HF2.
Jason_KeatingAltostratus
Occurs on 11.5.1 HF 3 also.
- Damiano_Colla_9
The correct procedure, as suggested by F5 support team, is to performing the following steps:
- deprovison vcmp
- run: tmsh delete sys disk application-volume vmdisks
- provision vcmp again
ATTENTION: the step number 2 destroys your virtual disks and guests.
It occurs in 11.5.0 HF4 too.
Telef__243_nicaI also have experienced this strange bug when deploying 11.5.1 HF5... but it seems not only cosmetical, because i experienced a strange behavior of the guests and the vCMP itself. Some of the jsp's don't appear on CU: iApps>Templates; System > Clustering > Properties.
Any other has experienced CU problems with this warning?
Thks. Javi
