Forum Discussion

Nimbostratus

May 04, 2018

TCP RST from remote system error in F5

Hi, I am unable to access the URL externally that i have defined in F5 for reverse proxy and it shows an error connection refused by host and the below error in F5 R 162:162(0) ack 982 win...

Cumulonimbus

May 04, 2018

Hello,

TCP RST from remote system:

When a host (client or server) sends a TCP RST for an existing TCP connection, the BIG-IP system in turns sends a TCP RST to the host at the other end of the TCP connection.

So I suppose that your backend server (Pool Member) send a reset first.

https://support.f5.com/csp/article/K13223

You alwayse receive a reset or sometimes?

regards

chandruv
Nimbostratus
Mar 15, 2024
sometimes, am getting this error?? what is the solution?
- zamroni777
  Nacreous
  Mar 15, 2024
  if the application layer is http/s then enable oneconnect in virtual server config (if haven't) to reduce number of tcp connection to servers.
  and is snat enabled?
  - chandruv
    Nimbostratus
    Mar 15, 2024
    I have an F5 load balancing setup configured with two servers. My MVC web application, which incorporates Kendo UI, Jquery, and bootstrapping, is hosted on an IIS server with an SSL certificate. However, when accessing the application via HTTPS from outside the server, it often or sometimes results in a 'net::ERR_CONNECTION_RESET' error, with intermittent failures to load javascript and CSS files to the client browser. Strangely, upon reloading the page, the assets load properly, and the page functions as expected. This issue did not occur when the application was accessed via HTTP, where it worked properly without any issues. What could be the reason behind this problem?