Forum Discussion
faizan123_23330
Nimbostratus
NimbostratusPing from source ip address
Hi,
I have F5 LTMs in our production environment. I assign the two different ip addresses on two interfaces (1.1,1.2)
1.1 --> 10.1.1.1
1.2 --> 20.1.1.1
The default route on the F5 is (0.0....
Stan_Ward
Altocumulus
AltocumulusWhen I try that (on 14.1.2.3), I get:
bind: Cannot assign requested address
It doesn't matter whether the IP is a self IP, a float, a SNAT, or a VIP, the message is always the same.
There are no route domains except the default %0.
Jimmy_L
Altostratus
AltostratusStan,
I had the same problem, but I found it was because I was in a different partition than the one in which my source self IP resided. From TMSH before switching to BASH do a "cd /<partition>" to switch to the partition where your self IP is, then switch to BASH an use Jad's ping command.