No SNAT statistics

how long has unit been running? u may check by running bigstart status. it will show how long it's.

86 days, we've got 4 LTMs and none of them are showing any SNAT stats. I've tried using the CLI and issued the 'b snat translation stats show' but get the error below. Its only recently I've been interested in the SNAT stats so this has probably never worked since got the F5s about a year ago.

 

 

BIGpipe SNAT query error:

 

01020036:3: The requested SNAT (translation) was not found.

 

 

Thanks

86 days, we've got 4 LTMs and none of them are showing any SNAT stats. I've tried using the CLI and issued the 'b snat translation stats show' but get the error below. Its only recently I've been interested in the SNAT stats so this has probably never worked since got the F5s about a year ago.

 

 

BIGpipe SNAT query error:

 

01020036:3: The requested SNAT (translation) was not found.

 

 

Thanks

how do u know u are using snat?

 

 

for command, can u try this?

 

b snat translation all show

All our virtual servers are configured with SNAT automap which we have to use because the web servers default gateway isn't the F5 LTM.

 

 

i've ran the command and it says no SNAT translations were found. Very strange as I can see connections on the virtual servers.

i've never seen snat automap stats. it's different from snat translation.

I'm in the same boat - all my LTMs use snat automap. How can I see the snat statistics? I'd like to keep an eye on them and know when to switch a VS over to using a SNAT pool instead of automap.

 

 

Thanks,

 

Jen

Good morning,

 

I'm in the same boat - all my LTMs are using SNAT Automap. How can I seee SNAT statistics?

 

Thanks, Miquel.

 

all my LTMs are using SNAT Automap. How can I seee SNAT statistics?

 

i do not think there is. there is request for enhancement but it has not been implemented.

 

ID248672 - RFE LTM STATS for SNAT automap similar to those available for SNATPOOL