ssh on slot1 failed f5 viprion

Hi Anzine321​ 

Here are a couple of cool points!

• On VIPRION, each blade (slot) can have its own management interface, but typically only the primary blade (slot 1, or the current "active" blade) is directly accessible via the management IP.
• The other slots (secondary blades) do not have separate management IPs by default; they are managed through the primary blade.
• SSH access is usually only available on the primary blade’s management IP. If you want to access other blades, you typically SSH to the primary blade and then use the ssh slotX command to access other slots.

Are you trying to SSH to the same management IP for all slots? If so, only slot 1 (the primary blade) will respond.

Verify physical and logical connectivity for slot 1’s management interface.

Thank you for reply. If possible, access slot 1 via the serial console (direct console connection) and Check logs for errors:

clsh tail -n 50 /var/log/ltm

clsh tail -n 50 /var/log/messages

Check Mgmt IP configuration if there any typo and also from a working blade (slot 2-4), run:

clsh tmsh list sys management-ip

and

clsh tmsh show net interface

If all else fails, try rebooting slot 1 

Update

interface management on blade 1 was down and now state up and i can access cluster management on slot 1

but ssh from host 1  still failed,

i tried to compare ssh and telnet on slot 2-4 work fine

telnet to port 443 

slot 1 : OK

slot 2 : OK

slot 3 : OK

slot 4 : OK

telnet port 22

slot 1 : Not OK

slot 2 : OK

slot 3 : OK

slot 4 : OK

and on qkview only show slot 2-4 and slot 1 missing and i tried to opencase this issue