Forum Discussion
Javatooo_40995
Nimbostratus
May 27, 2011Problem with Failover
Hi guys, I have two LTM with network failover. The config is synchronized and the interfaces are up, but when I forced the failover in the active box, this goes to standby. After when pass f...
Hi Mario,
Is the pool reachable via a TMM switch port (ie, not the mgmt port)? Do you see any packets being sent to the server? You can use tcpdump like this to check (where 1.1.1.1 is the syslog server):
tcpdump -enni 0.0 -Xs0 host 1.1.1.1
Aaron
- kmurphy_130520Feb 22, 2014
Nimbostratus
Master Configuration Process
Just stumbled upon it while reading an article about HA failover -- https://support.f5.com/kb/en-us/solutions/public/13000/900/sol13946.html
mcpd The master control program daemon is the messenger service that allows two-way communication between userland processes and the Traffic Management Microkernel (TMM).
sol13444: BIG-IP daemons (11.x)
http://support.f5.com/kb/en-us/solutions/public/13000/400/sol13444.html