Forum Discussion

f5beginner's avatar
f5beginner
Icon for Cirrostratus rankCirrostratus
Sep 04, 2019
Solved

Issue after upgrade from 14.1.0.1 build 0.0.7 to 14.1.0.6 build 0.0.9

Hi All,   I´m using Big IP VE on wmvare. I have upgraded BIG IP to new version, but I have a lot of problems.   Problems are connected with linux, after upgrade doesn´t work: winscp, I cannot i...
APM
application delivery
BIG-IP
  • iaine's avatar
    iaine
    Sep 05, 2019

    OK. Are you using the Management IP to SCP to the device rather than a Self IP? I'm assuming that you can SSH to this IP without issue, is this correct?

    If using a Self IP - what are your Port Lockdown settings set to?

    Do you have AFM provisioned? Do you have any AFM policies blocking your access?

    What account are you using to connect? If you are not using root, can you try using this a/c

    Is the SCP daemon running? ps aux | grep scp

    Are your SCP requests actually getting to your device. Close down any SSH sessions, then from vConsole run a tcpdump and see if your connection requests are hitting your F5

    tcpdump -ni eth0 port 22

iaine's avatar
iaine
Icon for Nacreous rankNacreous
Sep 04, 2019

Hi

 

If you don't install the config, then you will load the volume with the configuration that was on it when it was last used. So, if 1.1 was the volume that you upgraded from then you will get the config prior to your upgrade/reboot. If 1.1 is an empty volume, then you won't have any config.

 

Either way, if you reboot to 1.1 then you always have the option to reboot back to 1.2 if you want to, just don't select "Install Config"