Forum Discussion

Saskia_81056's avatar
Saskia_81056
Icon for Nimbostratus rankNimbostratus
May 23, 2013

http::respond in HTTP_RESPONSE

Hey guys,

 

i'm currently trying to write a iRule which spits out a HTML site for redirection purposes.

 

For this I have a HTTP_REQUEST in which I set a varible. In the HTTP_RESPONSE i check if this variable exists and if the status code is 404.

 

If so, I do a HTTP::respond 200 content "...html content here"

 

I tried it before without the status code check and put the same HTTP::respond code within the HTTP_REQUEST part which was working like a charm.

 

But as soon as I put it within the HTTP_RESPONSE part the site just gives me a RESET.

 

I also tried it plain without any ifs which also wasn't working.

 

 

when HTTP_RESPONSE {

 

log local0. "Test"

 

HTTP::respond 200 content "bla"

 

}

 

 

The HTTP_RESPONSE fires which I can see in the log but then I just get a reset.

 

 

Do you know this behavior? Am I doing anythin wrong??

 

 

Best Regards

 

Sam

 

application delivery
dev
devops
iRules

1 Reply

  • nitass's avatar
    nitass
    Icon for Employee rankEmployee
    May 23, 2013
    does curl work? 

    [root@ve10:Active] config  b virtual bar list
virtual bar {
   snat automap
   pool foo
   destination 172.28.19.252:80
   ip protocol 6
   rules myrule
   profiles {
      http {}
      tcp {}
   }
}
[root@ve10:Active] config  b rule myrule list
rule myrule {
   when HTTP_RESPONSE {
  log local0. "Test"
  HTTP::respond 200 content "bla\r\n"
}
}
[root@ve10:Active] config  curl -i http://172.28.19.252
HTTP/1.0 200 OK
Server: BigIP
Connection: Keep-Alive
Content-Length: 5

bla