Forum Discussion

  • Snl's avatar
    Snl
    Icon for Cirrostratus rankCirrostratus
    May 09, 2017

    Hi

     

    we have done the upgrade ( F5-3600) from 10.2.4 HF13 to 11.6.1 HF1 version with few changes in config mainly related http profile & asm related configs , it will be direct upgrade.

     

    i would suggest apply latest hotfix in 10.2.4 train then proceed for direct upgrade to 11.6.1 hf2 , if you have ha setup , upgrade the standby box first and switch the services and monitor for 1 days then upgrade the other box

     

    the procedure for upgrade will remain same , activate the license before upgrade.

     

    Good Luck

     

    cheers/Snl

     

  • Ganesh_Garg's avatar
    Ganesh_Garg
    Icon for Nimbostratus rankNimbostratus
    May 09, 2017

    Please find the steps to upgrade HA setup below: -

     

    1. Take qkview of both devices.
    2. Download the version you want to upgrade to along with MD5 file from
    3. Upload the version on both unit via GUI or via CLI(/shared/mages)
    4. Match the MD5 from CLI (run md5sum) if value matches with the file then you are good to go.
    5. Install the ISO to one of the available disk (HD1.1/HD1.2/HD1.3/etc).
    6. Make the standby device in "force-offline" mode
    7. Post installation reactivate the license, once you get configuration verified then you can reboot the box into another HD.
    8. Reboot the box with new HD and don't forgot to import the configuration from existing HD.
    9. Once rebooted, verify the configuration, post successful verfication remove the force-offline mode. Device should be in standby mode with SYNC-FAILED.
    10. Login to Active unit and make it standby and newly upgraded unit should be Active.
    11. Repeat steps 7-9.

    //Ganesh