How to reset only the bigip.conf to factory default settings

Can you tell me how we can configure redundancy between two Big-IP using serial port.Becuase if we do the redundancy using serial port then how the configuration would be sync between two appliance.there are two different things. one is failover and the other one is configsync. failover can be done by either hardware (serial cable) or network. configsync needs network.

 

 

One more query is that If we deploy two Big -IP with redundancy then is it required to configure the internal and external vlan as in our topology Server default gateway is not big-ip and there is multiple VLANs in the switch for different Zone.

 

 

So should we have to use both npath routing and SNAT configuration in Big-IP ??there is no requirement in number of vlans. you just make sure bigip sees both requset and response traffic (e.g. using default gateway, snat) unless you are using npath.

 

 

For your information , If we do multiple self IP and as well as multiple floating IP in version 10.x ,then which self ip would used for configuration synchronization.configsync has to use non-floating selfip.