Forum Discussion
Hello,
Since you don't need all config, and just pool and virtual servers and some LTM objects, you can open the bigip.conf file (from the source device that you need to copy config from), and start copying the configuration as text, and then migrate these objects using the below command:
Access new device
#load sys config from-terminal merge verify
and verify for any erros and try to fix them, Then run the same command without verify.
#load sys config from-terminal merge
https://my.f5.com/manage/s/article/K81271448
Thanks,
Salah
angerica I have not migrated from one to the other but you might try the following.
- angericaNimbostratus
Hi SIr
Thank you for the kb, i was wondering as there is existing configuration for viprion, if i load the ucs file from boh-ip 5050 to virpiron what willh happen to the existing config of virpion?
Presume the Viprion has vCMP guests? And you are migrating a config from an older device to a vCMP guest? If so, you can copy over the UCS and load it on the vCMP guest. Please take a look at the following:
https://my.f5.com/manage/s/article/K14906
The vCMP guest will already be licensed by virtue of the Host/Chassis being licensed. However, you will need to make sure the appropriate modules are licensed. You would then be able to export the UCS from the old unit, and import into the new vCMP guest. Load the UCS with no license and no platform checks. Then remap the VLANs to the appropriate interfaces... which has to be done on the Host! So, make sure on the host you have those VLANs defines with the same name, attach to the vCMP guest, and then you should be good to go.