Cannot access machines after TLS 1.0 and 1.0 was disabled in server side(both vip and pool members on port 443 without any client or server ssl profile)

Hi Daniel,

Thank you for your reply and sorry for the delay in response , not able to access service means the service is not down in ltm , however when the application team disable TLS1 and 1.0 on their servers, the ldap(ADFS ) stops working , they suspected something on the F5 for which I specified that F5 is only a pass though ,I strongly felt this is something related to application however I wanted to confirm it .

I referred the below and it says SSL Pass through traffic where BIP IP just pass the the traffic from client to servers , So I only wanted to make sure that we are right that F5 does not do any reset when they disable tls v1 v0 on their servers , second it since this is production we have not got chance for any downtime to test it again.

https://support.f5.com/csp/article/K65271370 #

the health monitor is tcp

here is the same sample

ltm virtual VIP12_443 {

  destination VIPex/172.16.1.1:https

  ip-protocol tcp

  mask 255.255.255.255

  pool pp

  profiles {                                                     ----------------------- No Client or sever SSL profile attached  / Health Monitor is tcp

    tcp { }

  }

  source 0.0.0.0/0

  source-address-translation {

    type automap

  }

  translate-address enabled

  translate-port enabled

  vlans {

    /bb

  }

  vlans-enabled

  vs-index 25

}