Forum Discussion
Johnmec_45780
Nimbostratus
NimbostratusBIGIP remote config file transfer
Hi !
I hope this has not been asked already..
Is there any way to easily transfer and load bigip main config files (bigip_base.conf and bigip.conf) from a remote host? I mean a way to do it programmatically, using iControl and/or perhaps some other Perl module?
Thanks!
David
11 Replies
- Hey Mark,
The routines use chunking - think of it as virtual blocks, where you send a small amount at a time and iControl reassembles it with concatenation on the back end - as far as I know, the theoretical limit is on disk space available.
Don.
