Forum Discussion
Cirrostratusactive standby
Good day all,
Apologies, i have read f5 documents but can't get hold of how the active-standby on big-ip will work or is configured to work.
Please help to understand how to find out what has been configured in the big-ip for it to behave or activate during a situation where it will change roles from standby to active.
In our self device, i see unicast address has been configured for ha & ha2 but it doesn't show what may cause the change of roles?
Thank you all in advance.
- Lidev
Nacreous
Hello suthomas1,
Everything you need to know is covered in these links below, you will find the answer to your questions.
BIG-IP Device Service Clustering: Administration
BIG-IP Device Service Cluster Configuration (LAB)
BIG-IP Device Service Clustering (video)
The unicast failover configuration uses a self IP address and Traffic Management Microkernel (TMM) switch port to communicate failover packets between each BIG-IP members.
Regards
- Mayur_Sutare
MVP
Hi ,
If you go through the Device Group and Traffic Group, you will get more idea about the HA configuration and failover part. Sync-Failover device group type is responsible for config sync and HA failover to another device when primary active unit becomes unavailable. Traffic group is collection of Floating/Self IPs, Virtual Servers and defines the failover order. In case device device becomes unavailable, traffic group failovers to another available device in a device group.
