virtual server fault tolerance (active-passive)

Question

Hi,I have two servers that are working in active-passive mode.Each server has a unique DNS entry.The active server has been configured in F5 and is working properly.The goal is to be able to use a single URL and to have F5 forward the traffic to the active server based on the state of the servers.appliance version is&nbsp;12.1.2Thanks,Felix&nbsp;&nbsp;

sebastiansierra · Answer

Hi,You can use&nbsp;Priority Group Activation to assign a higher value to the principal server, and, if it fails, send the request to the second server with a lower&nbsp;Priority Group Activation.Follow this link to configure it:https://support.f5.com/csp/article/K13525153#:~:text=To%20enable%20priority%20group%20activation,in%20a%20lower%20priority%20group.

fz · Answer

Thank you for your response.This does not achieve the goal of a single URL for both servers...As my chname points to one virtual server..

fz · Answer

Hi,unfortunetly not yet..

Forum Discussion

virtual server fault tolerance (active-passive)

3 Replies

Recent Discussions

Overwriting or adding LTM SSL Traffic cert and key using iControlREST

F5 Access Guard Deprecated: ZTA APM

F5 loadbalancer not working

Pricing when used with aws waf

F5 terminal - help to run commands - disk space full

Related Content

Especial Load Balancing Active-Passive Scenario (I)

Especial Load Balancing Active-Passive Scenario (II)

Integrating SSL Orchestrator with Fortinet FortiGate Virtual Edition as a Virtual Wire

Quick Optimizations for F5 BIG-IP Virtual Edition

Active/Passive VIP - 2 different DC's