I really confuse with SNAT regarding config. i know it change Source address. but config little confuse somet time
theee 2 way i saw config
I select in pool SNAT and in virtual server "NONE"
here is connection entry.
show sys connection cs-server-addr x.x.x.x with this I see only three column
CLEINT source address Virtual server ip member of pool
WITH THIS FIRST CONFIG >>>> SNAT WORKS ?
I select in POOL SNAT and in virtual server i select "SNAT AUTOMAP" with this i see Four column
CLEINT source address Virtual server ip SNAT IP member of pool
1. when should i configure first configuration and when should i configure second config .?
2. IF in pool i don't select SNAT and in virtual server i select "SNAT AUTOMAP" will SNAT WORKS ?
Thanks & Regards
snat can be used by itself (local traffic > snat > snat list) or configured under virtual server configuration. when configuring both, snat under virtual server will take precedence. however, when snat list is configured but no snat is configured under virtual server, snat list will also be applied.
sol7820: Overview of SNAT features