Forum Discussion
3 Replies
Sort By
- Vijay_ECirrus
You may want to open a case to confirm with F5 but I think just provisioning the resource and rebooting the standby unit should suffice.
- SurgeonRet. Employee
Just provision the 2d module as usual and sync the boxes.
- Katherine_VillaAltostratus
Hi.!! I think you dont need to reboot the standby unit, because it adjust the provisioning settings with the new one. It goes out for some seconds.
I need to add a third one unit to my cluster. The cluster is configure with AAM as Dedicated. I want to add the third one, and enable AVR too. I'm not clear about the correct order to do this.