Forum Discussion

Nikoolayy1's avatar
Jan 26, 2022

Knowledge sharing: F5 Software Upgrade/RMA process

Here is quick summary about things should be checked before an F5 upgrade.

This is the general F5 support article with clips and there is nice info for VIPRION and VCMP systems:

This a great community article

 

Extra addition to the DNS upgrade is that it is better upgrade first the LTM devices that the DNS devices monitor and after the upgrade of 1 or 2 DNS systems till the other DNS systems are also upgraded better upgrade the big3d process on the older DNS systems in the DNS sunc group:

For BIG-IQ upgrade or for BIG-IQ to upgrade f5 devices:

 

For F5 devices with the F5 APM module after upgrade check if the installed F5 Edge Client software needs to be upgraded as it may not work with the new F5 APM TMOS version.

 

An issue I have seen is to install the new version in a volume and transferring the configuration from the old volume to the new but without activating it and then to activate it after a week and there would an old configuration during that week many changes were done on the old volume config, so better before an upgrade so save UCS just in case from the old volume/partition:

Some workarounds:

 

F5 RMA process general articles:

F5 general articles for RMA with or withour UCS as without UCS the system and network settings may need to be configured manually and the configuration to be synchronized from the active device to the rma device.

For F5 DNS/GTM there are special steps:

F5 RMA of VIPRION chassis or a blade as for example when the new blade is installed but the active software version on other blades and vcmp quests is missing then the blade  will get stuck in quorum for the chassis or vcmp quest as the primary blade will not be able to update it. If there is single blade in the chassis better hope that there is saved UCS expecially if there are vCMP quests as then for every vcmp quest the system and network need to be manually configured and the other config can be synchronized from the other chassis and vcmp quests that are in HA cluster.

As the F5 VIPRION chassis is most complex  (see K14302) if there is no saved master key as the vCMP quests use keys that are signed by the vCMP host master key and if it is lost then it is really complex, this is a nice F5 devcentral procedure how to generate your own master key that can be the same for the different F5 VIPRION Devices:

 

When loading UCS on the RMA device that has containing encrypted passwords or passphrases, you can check(I have never used the second article but it is nice to have if issues are seen on a vCMP system when a chassis is replaced):

The new F5 Joutneys tool can be used for migrating to configuration to the new F5 VELOS and rSeries  platforms and maybe in the future the F5 NEXT Operational System.

 

 

For the F5 imish/zebos routing module it is good to renember that that the config is not synchronized in a HA pair and before an RMA/upgrade to run the "write" command in the module as this is like the F5 command "save sys config" for CLI made changes as because of the reboot of the devices this changes can be lost.

 

Before the license reactivation I suggest using the tool https://secure.f5.com/validate/validate.jsp to check that you have legitimate license and support contract.

4 Replies