F5 Migration

Hi Gemini6,

When you restore a HA UCS to a single unit, it will assume Active Unit config, IP addresses, etc and create IP conflict on the network.

I would setup a single unit on a network and disable its ports ( internal, external, dmz etc.) probably at the network switch level and made it accessible only from its management port.

Then I will restore the UCS to a single unit and verify the configuration. May be adjust IP addresses if needed and then bring it live on the network.

The single unit also assume there will be a standby unit and have HA config. You can either leave it as is or may be clean up.

I hope it helps.

-Muhammad