Forum Discussion
Sarah_258804
Cirrus
CirrusWhy is an Active-Active configuration not recommended by F5?
I was considering configuring our F5 LTMs in an Active/Active state within Cisco ACI but I read here
that this type of configuration is not recommended without having at least one F5 in standby mode...
Sumanta_88744Cirrus
CirrusHi Sarah
You can successfully use active-active on LTM. If you are having TMOS version 11.x and later, then it is easier to deploy using DSC. Just ensure that you have more than one traffic group such that the 1st traffic group is active on one LTM node and the 2nd traffic group is active on the other.
Regards
Sumanta.